Enviro S50 - Rear Chassis Removal

17
Removing the ReaR chassis
Maintenance And Service
1. Remove the door frame and skirt (see remoVing
Door Frame/Skirt section on page 15).
2. Remove the venturi knob located on the back of
the unit (see Figure 6). It can unscrewed by hand
and put aside.
3. Position yourself in a way that allows you to sup-
port the chassis once detached. Remove the four
mounting screws using a 5/16” socket (see Figure
21). There are two spacers at the bottom on the
backside that support the rear chassis weight (see
Figure 22). The chassis will pivot backwards once
fully detached.
4. Lift up to disengage the slot from the spacers
and pull away from the unit (See Figure 23).
When remounting, position chassis slots over
both spacers and pivot up and reattach screws.
Due to mild warping, the chassis may need to be
squeezed inward to align slots.
Remove
Figure 21: Rear Chassis Detachment
Figure 22: Rear Chassis Spacers Figure 23: Rear Chassis Removal