15
Maintenance And Service
The safety screen mounting position can be adjusted slighlty
to maining paralellism with the fireplace body lines. The outer
standoffs on the lower screen can be repositioned by loosening
the two T20 screws and adjusting via slots, retighten screws.
Figure 15: Safety Screen Adjustments
Removing the DooR fRame/skiRt
The door frame and skirt will need to be removed to gain firebox and component access. Take care not to
scratch any painted surfaces.
Removing/mounting the DooR fRame
The door frame is attached with four hooks (two on each side) that interlock with slots on the chassis.
Remove: Lift top plate and set support hinges (see “Lifting The Top Plate” section for details), then grab the
frame on either side and lift up to disengage hooks and bring out.
Mounting: There are two different sections in each mounting slot (see Figure 16). The door frame should
fit relatively easily into section 1, it may be easier to mount one side first then the other. Once all hooks are
engaged in their respective slots, push in one side of the door frame (top and bottom) until the hooks drop
into the section 2; repeat this on the opposite side. This will firmly lock the door frame into position and close
up any excessive gaps.
NOTE: If door frame mounting is proving difficult, the curved glass may not be clamped properly creating
and interference with the door frame.
Section 1
Section 2
Section 1
Section 2
Section 1
Section 2
Section 1
Section 2
Figure 16: Chassis Mounting Slots
To Next Page
Loading...
