Enviro S50 - Front and Rear Skirt Removal; Glass and Rear Chassis Maintenance; Glass Removal and Replacement

16
Removing the gLass
Remove the door frame (see previous section for details). The curved glass is retained using four clamps: one
on each side, one on the top and bottom. To remove the glass: Loosen the two side retainers using a 5/16”
socket (see Figure 19re 19). Next, fully remove the top and bottom curved retainers using a 3/8” socket (see
Figure 20). Shimmy the glass forward then grab it top and bottom by hand and carefully remove.
Loosen
Maintenance And Service
Removing the fRont skiRt
Remove: After the door frame is removed, the skirt can be removed to gain component access by lifting up
at either end to disengage the hooks and brought out.
Mounting: Place the skirt hooks into their respective chassis slots and the center stud support rest in the finger
groove. Ensure proper hook setting is used for your pedestal option.
The notches closest to the end of the hook should be used when installed with a pole pedestal. The notches
closest to the body of the skirt should be used when installed with a wood pedestal (see Figure 18 for detailed
view).
Figure 17: Front Skirt Attachment
*NOTE: To reattach the glass, perform the above instruc-
tions in reverse order. IT IS IMPORTANT THAT THE TOP
AND BOTTOM RETAINERS ARE INSTALLED FIRST AND
FULLY TIGHTENED. Not doing so can result in door frame
mounting interference.
Pole pedestal
Wood pedestal
Figure 18: Front Skirt Attachment
Figure 19: Glass Side Retainer Figure 20: Glass Top/Bottom Retainer
WARNING: No substitute materials or parts can be used. ONLY glass supplied from the manufacturer
may be used (replacement part number: 50-4188).