53
STEP 6: Place Log 6 atop the flat surface of Log 5; the base
should contact the firebox edge. See Figure 96.
Secondary Installation
STEP 7: Place the narrow notch underneath Log 7 into the
groove on Log 4. The right side of the log should contact
the firebox edge and spaced off the burner slot by 1/4”
(6mm). See Figure 97.
STEP 8: Log 8 should notch onto Log 7
nicely. See Figure 98.
STEP 9: Continue placing shale and/or
vermiculite between the logs as de-
sired. Do not cover up any air slots.
Figure 96: Step 6 - Log 6
Figure 97: Step 7 - Log 7
Figure 98: Step 8 - Log 8
*Note: It is important that Log 7 is placed correctly as
specified in the instructions. There is a notch located on
its back side (facing the burner) that should be placed
to the right of the pilot as shown in Figure 99. Failure to
place the log properly could result in problems with the
pilot.
Figure 99: Log 7 Placement (Top View)
To Next Page
Loading...
