45
Initial Installation
QUALIFIED INSTALLERS ONLY
Figure 68: Vent Adapter Attachment
Figure 69: Rear Chassis Punchout
Figure 70: Top Plate Blank Supports
11. Attach the vent adapter over top of the exhaust
spigot (see Figure 68).
12. Remove the punchout from the rear chassis
using a sizeable hammer (see Figure 69). Place
a cloth down around the perimeter to prevent
damage to the chassis in case you accidently
strike the painted surface.
Figure 71: Top Plate Blank
13. Install the two top plate blank supports and nuts
(included in the manual bag) on the four (4) studs
underneath the top plate (see Figure 70).
14. Reattach the rear chassis, glass, door frame, and
top plate to the unit.
15. Place the top plate blank (included with the unit)
into the top plate (see Figure 71).
To Next Page
Loading...
