Maintenance and Transportation 165
7
7
7
7
7
7
7
7
7
7
7
7
10. Confirm the error message on the LCD panel. When an other
toner cartridge needs to be replaced, an error message is
displayed. Repeat steps 3 to 8 and replace the cartridge.
Photoconductor Unit
Handling precautions
Always observe the following handling precautions when
replacing the consumable products:
❏ The photoconductor unit weighs 3.0 kg (6.6 lb). Be sure to hold
it firmly by the handle when carrying it.
❏ When replacing the photoconductor unit, avoid exposing it
to light any longer than necessary.
❏ Be careful not to scratch the surface of the drum and belt. Also,
avoid touching the drum, since oil from your skin may
permanently damage its surface and affect print quality.
❏ To get the best print quality, do not store the photoconductor
unit in an area subject to direct sunlight, dust, salty air, or
corrosive gases (such as ammonia). Avoid locations subject to
extreme or rapid changes in temperature or humidity.
❏ Do not tilt the photoconductor unit.
w
Warning:
❏ Do not dispose of the used consumable products in fire, as
they may explode and cause injury. Dispose of them
according to local regulations.
❏ Keep consumable products out of the reach of children.
To Next Page
Loading...
