Paper Handling 39
2
2
2
2
2
2
2
2
2
2
2
2
❏ You can also make these settings on the Tray Menu in the
control panel. See “Tray Menu” on page 251.
Loading a custom paper size
You can load non-standard size paper (90 × 110 mm to 220 ×
297 mm) into the MP tray as long as it meets the following size
requirements:
When loading a custom paper size, you should make paper
settings as shown below:
❏ Make settings on the Basic Settings menu in the printer driver.
Note:
❏ For Windows, access the printer driver, then select
User-Defined Size from the Paper Size list on the Basic
Settings menu. In the User Defined Paper Size dialog box,
adjust the Paper Width, Paper Length, and Unit settings to
match your custom paper. Then click OK and your custom
paper size will be saved.
❏ For Macintosh, access the printer driver, click Custom Size
in the Paper Setting dialog box. Then click New, adjust the
Paper Width, Paper Length, and Margin settings to match your
custom paper. Then enter the setting’s name, and click OK to
save your custom paper size.
❏ You can also make these settings on the Tray Menu in the
control panel. See “Tray Menu” on page 251.
Paper Size: User defined size
Paper Source: MP Tray (up to 20 mm thick stack)
Paper Type: Plain, Semi-Thick, Thick or Extra Thick
To Next Page
Loading...
