224 Troubleshooting
Remove Photoconductr
When setting up the printer, the photoconductor unit was
installed before all toner cartridges were installed.
Open cover B, remove the photoconductor unit, then close cover
B.
Replace Photoconductr
The photoconductor has reached the end of its service life. Replace
the photoconductor unit with a new one. See “Photoconductor
Unit” on page 165 for instructions.
The error clears automatically after you replace the unit and close
all printer covers. The photoconductor service life counter is reset
automatically.
When the error light is blinking, you can continue printing by
pressing the N Start/Stop button. However, the print quality is
not guaranteed from then on.
Replace Toner uuuu
The Toner cartridge for the indicated color has reached the end of
its service life. Replace the cartridge with a new one.
The error clears automatically after you replace the cartridge and
close all printer covers. The toner cartridge service life counter is
reset automatically.
Reset
The printer’s current interface has been reset and the buffer has
been cleared. However, other interfaces are still active and retain
their settings and data.
To Next Page
Loading...
