246 Using Options
Removing the Adobe PostScript 3 ROM module
Follow these steps to remove the Adobe PostScript 3 ROM
module:
c
Caution:
Before you remove the ROM module, be sure to discharge any
static electricity by touching a grounded piece of metal.
Otherwise, you may damage static-sensitive components.
w
Warning:
Be careful when working inside the printer as some components
are sharp and may cause injury.
1. Make sure the printer is off, then unplug the power cord.
2. Remove all interface cables from the interface connectors.
3. Loosen the two screws on the back of the printer.
To Next Page
Loading...
Need help?
General