1. With the main screen (Scan mode) or Can Use AddressBook displayed, press the Addressbook
key four times so that PHONE BOOK appears.
2. Press the u or d key to select LDAP SEARCH, and then press the Select key.
3. Press the u or d key to select NAME or E-MAIL, and then press the Select key.
Note:
To search registered names, select NAME. To search e-mail addresses, select E-MAIL.
4. Use the keypad to type in the search keyword (maximum of 10 characters), and then press the
Select key.
The search begins, and the search results appear after a while. If no data matches the search
keyword, NOT FOUND appears for about two seconds.
Note:
❏ For details on entering/editing text, refer to the Facsimile User’s Guide.
❏ Text starting with the first character of the maximum 10 characters is searched for. Text will not
be found if the search keyword is in the middle of a word.
5. Press the u or d key to select the desired data, and then press the Select key.
Note:
❏ To check the found information, press the r key.
❏ An e-mail address exceeding 64 characters cannot be specified. If such an e-mail address is
specified, ADDRESS IS TOO LONG appears for about two seconds, and then the screen for
specifying the destination address appears.
❏ To narrow down the search results, press the Back key, and then perform step 4 again.
6. Press the Select key again.
7. Press the u or d key to select FINISH, and then press the Select key.
Note:
To add an additional e-mail address, select ADD in step 7, and then specify the destination.
To edit the specified e-mail address, select CHECK/EDIT
in step 7, and then continue with step 2 of
“Editing a Specified Destination Address”.
To delete a specified e-mail address, select CHECK/EDIT in step 7, and then continue with step 2 of
“Deleting a Specified Destination Address”. The address cannot be edited.
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Using the Scanner 104
To Next Page
Loading...
Need help?
General
