Note:
Changes made with this procedure will not be applied to the original data (speed dial destination, group
dial destination, etc.).
1. In the main screen (Scan mode), press the u or d key to select UTILITY, and then press the Select
key.
2. Press the u or d key to select DIAL REGISTER, and then press the Select key.
3. Press the u or d key to select FAVORITE, and then press the Select key.
4. Press the u or d key to select CHECK/EDIT, and then press the Select key.
5. Press the u or d key to select the address to be deleted from the favorite list, and then press the
Stop/Reset key.
6. Press the u or d key to select YES, and then press Select key.
The selected address is deleted.
7. To delete another address, repeat the procedure from step 5.
8. To finish deleting addresses, press the Back key.
9. Press the u or d key to select FINISH, and then press the Select key.
Registering Speed Dial Destinations (Direct Input)
E-mail addresses can be registered as speed dial destinations. A maximum of 250 speed dial
destinations can be registered.
Note:
❏ Machine key operations cannot be used to register an FTP address or SMB address as a speed dial
destination. These addresses can be registered with Local Setup Program or EpsonNet Config. For
details, refer to the Reference Guide.
❏ Speed dial destination numbers 221 to 250 are reserved for registering FTP addresses and SMB
address from Local Setup Program or EpsonNet Config.
1. In the main screen (Scan mode), press the u or d key to select UTILITY, and then press the Select
key.
2. Press the u or d key to select DIAL REGISTER, and then press the Select key.
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Using the Scanner 108
To Next Page
Loading...
Need help?
General
