This message... means... Do this...
USB Dev.Not support A USB device incompatible
with this machine is
connected.
Disconnect the USB device from
this machine.
USB Hub Not support A USB hub is connected to this
machine.
This machine is not compatible
with a USB hub. When connecting
USB cables to this machine, do not
use a USB hub.
USB MEMORY FULL There is no space available on
the USB memory device
connected to this machine.
Delete data from the USB memory
device to create free space, or use a
different USB memory device.
Video I/F Error A video interface error
occurred in the machine.
Turn off the machine. After a few
seconds, turn on the machine.
WRONG PASSWORD
xxx Server
The password is incorrect, so
the indicated server could not
be accessed.
Check the password, and then
specify the correct one.
Wrong Toner x An inappropriate toner
cartridge is installed.
Install only the toner cartridge
listed in “About Toner Cartridges”
on page 117.
xxx COVER OPEN
CLOSE xxx COVER
The indicated cover is open. Close the indicated cover.
The photoconductor unit is
not installed.
Install the photoconductor unit.
A photoconductor unit
incompatible with the
machine is installed.
Replace the photoconductor unit
with a correct one.
xxx IS DISABLED The TCP/IP, FTP, SMTP or SMB
settings are disabled.
Enable the TCP/IP, FTP, SMTP or
SMB settings.
xxxxx
IS NOT SUPPORTED
Repeat copying cannot be
performed with the specified
paper size.
The maximum possible size for
repeat copying is A4.
Specify a paper size of A4 or
smaller.
xxx SERVER ERROR The file cannot be saved on
the indicated server.
Check the status of the indicated
server.
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Troubleshooting 196
To Next Page
Loading...
Need help?
General
