REMOTE MONITOR Setting
OFF / ON
Select whether or not setting remote monitor.
If ON is selected, technical support can access the menu mode.
If OFF is selected, technical support cannot access the menu
mode.
Note:
This setting is for technical support uses. Change the setting
only when it is necessary.
NETWORK
SETTING
TCP/IP Setting
DISABLE / ENABLE
Select the setting for connecting to this machine through a
network.
IP ADDR. SETTING
*1
Setting
AUTO / SPECIFY
Set the IP address of this machine on the network.
If AUTO is selected, the IP address will be assigned automati-
cally.
If SPECIFY is selected, manually specify settings for IP AD-
DRESS, SUBNET MASK and GATEWAY.
DNS CONFIG.
*1
Setting
DISABLE / ENABLE
Set whether or not the DNS server setting is to be specified.
If ENABLE is selected, specify DNS server addresses (up to
three addresses).
DHCP
*1
Setting
DISABLE / ENABLE
If there is a DHCP server on the network, specify whether the IP
address and other network information is automatically as-
signed by the DHCP server.
BOOTP
*1
Setting
DISABLE / ENABLE
If there is a BOOTP server on the network, specify whether the
IP address and other network information is automatically
assigned by the BOOTP server.
ARP/PING
*1
Setting
DISABLE / ENABLE
Select whether or not the ARP/PING command is used when
the IP address is assigned.
HTTP
*1
Setting
DISABLE / ENABLE
Select whether or not to enable HTTP.
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Control Panel and Configuration Menu 36
To Next Page
Loading...
Need help?
General
