❏ Stuck together with static electricity
❏ Composed of foil or gilt; too luminous
❏ Heat sensitive or cannot withstand the fusing temperature (180˚C [356˚F])
❏ Irregularly shaped (not rectangular or not cut at right angles)
❏ Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
❏ Acidic
❏ Any other media that is not approved
Thick Stock
Paper thicker than 90 g/m (24 lb bond) is referred to as thick stock. Test all thick stock to ensure
acceptable performance and to ensure that the image does not shift.
You can print continuously with thick stock. However, this could affect the media feed, depending on
the media quality and printing environment. If problems occur, stop the continuous printing and
print one sheet at a time.
Capacity Tray 1
Up to 50 sheets, depending on their thickness
Tray 2
*1
Not supported
Orientation
Face up
Driver Media
Type
Thick Stock 1
Thick Stock 2
Weight
Thick Stock 1: 91 to 163 g/m (25 to 43.5 lb bond)
Thick Stock 2: 164 to 209 g/m (43.6 to 55.6 lb bond)
Duplexing
*1
Not supported
*1
Only for AcuLaser CX16NF
DO NOT use thick stock that is
❏ Mixed with any other media in the trays (as this will cause media misfeeding)
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Media Handling 52
To Next Page
Loading...
Need help?
General
