27
Installation Safety Precautions
When choosing a location to install the projector and performing the installation, note the precautions
below:
• You must install a ceiling mount when suspending the projector from a ceiling.
• If you do not install the projector correctly, it could fall and cause damage or injury.
• Do not use adhesives on the mounting hole to prevent the screws from loosening, or use lubricants,
oils, or similar substances on the projector; the projector case may crack causing it to fall. This could
cause serious injury to anyone under the ceiling mount and could damage the projector.
• Do not install the projector in a location subject to high levels of dust or humidity,or in a location
subject to smoke or steam. Otherwise, it could cause a fire or electric shock to occur. The projector's
case could also deteriorate and be damaged causing the projector to fall from the mount.
• Examples of environments that could cause the projector to fall due to case deterioration
• Locations subject to excessive smoke or airborne oil particles, such as factories or kitchens
• Locations containing volatile solvents or chemicals, such as factories or laboratories
• Locations where the projector could be subjected to detergents or chemicals, such as factories or
kitchens
• Locations in which aroma oils are often used, such as relaxation rooms
• Near devices that produce excessive smoke, airborne oil particles, or foam at events
• Locations near humidifiers
• Do not cover the projector's air intake or air exhaust vents. If the vents are covered, the internal
temperature could rise and cause a fire.
• Do not use or store the projector in locations where it will be subject to dust or dirt. Otherwise, the
quality of the projected image may decline, or the air filter may become clogged, resulting in a
malfunction or fire.
• Do not install the projector on an unstable surface or in a location beyond the weight specifications of
the projector. Otherwise, it could fall or topple causing an accident and injury.
• When installing the projector in a high position, take measures to prevent falling by using wires to
ensure safety in an emergency, such as an earthquake, and to prevent accidents. If it is not installed
correctly, it could fall causing an accident and injury.
• Do not install in locations where salt damage could occur, or in locations subject to corrosive gas such
as sulphuric gas from hot springs. Otherwise, corrosion could cause the projector to fall. It could also
cause the projector to malfunction.
To Next Page
Loading...
