53
Attention:
• You can adjust the position from -30 to +120 degrees vertically.
• Do not tilt the projector up or down beyond its range of movement. Doing so may cause a
malfunction.
3. To adjust the horizontal position of the projected image, turn the projector stand left or right as
shown below.
Attention:
• Turn the projector stand slowly. Turning it with too much force may cause a malfunction.
• Do not turn the projector stand left or right beyond its range of movement. Doing so may cause a
malfunction.
• Do not turn the projector stand by holding the cables connected to the projector's ports. Doing so
may damage the cables or ports.
If the projected image is unevenly rectangular, you need to adjust the image shape.
Parent topic: Using Basic Projector Features
Image Shape
You can project an even, rectangular image by placing the projector directly in front of the center of the
screen and keeping it level. If you place the projector at an angle to the screen, or tilt it up or down, or off
to the side, you may need to correct the image shape.
After correction, your image is slightly smaller.
For the best quality images, we recommend adjusting the installation position of the projector to achieve
the correct image size and shape.
To Next Page
Loading...
