91
Adjusting a Fuzzy or Blurry Image
If the projected image is fuzzy or blurry, try the following steps until the problem is solved.
Note: Focus and keystone distortion of the projected image are automatically corrected under the
following conditions:
• When the size of the projected image (diagonal length) before correcting focus and keystone distortion
is from 30 to 100 inches.
• When the projection distance is about 28 to 87 inches (0.7 to 2.2 m).
• When the installation angle of the projector toward the projection surface is within 20º right, left, up, or
down.
1. Hold down the focus button on the remote control to perform Auto Focus.
2. Press the focus button on the remote control to display the focus adjustment screen and adjust
focus manually.
3. Check the following items:
• Position the projector close enough to the screen.
• Position the projector so the keystone adjustment angle is not so wide that it distorts the image.
4. Clean the projector's lens.
Note: To avoid condensation on the lens after bringing the projector in from a cold environment, let
the projector warm up to room temperature before using it.
5. Adjust the Sharpness setting in the projector's Display & Sound menu to improve image quality.
• Display & Sound > Picture > Custom > Sharpness
6. If you are projecting from a computer, use a lower resolution or select a resolution that matches the
projector's native resolution.
Note: If you cannot correct the focus and any distortion of the projected image, turn off the projector and
disconnect the power cord, then reconnect the power cord and turn the projector back on. If a warning
screen is displayed when you turn on the projector, contact Epson for help.
Parent topic: Solving Image or Sound Problems
To Next Page
Loading...
