0-2
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
INTRODUCTION
This Service Manual describes basic functions, theory of electrical and mechanical operations,
maintenance and repair procedures of the EMP-822/EMP-83/EMP-X5/EMP-S5. This informa-
tion is intended for the experienced repair technicians, and attention should be given to the pre-
cautions on the preceding pages.
This manual consists of four chapters and Appendix.
NOTICE
All rights reserved. No part of this manual may be reproduced, stored in retrieval system, or
transmitted in any form or by any means, electronic, mechanical, photocopying, recording,
or otherwise, without prior written of SEIKO EPSON CORPORATION.
The contents of this manual should be handled with sufficient consideration for confidenti-
ality reasons.
After publication of this manual, the parts and mechanism may be subject to change for
improvement of their performance. Therefore, note that the descriptions given in this man-
ual may not coincide with the actual machine.
Other company or product names used herein are for identification purpose only and may
be trademarks or registered trademarks of their respective owners. EPSON disclaims any
and all rights in those marks.
Copy right © 2007 SEIKO EPSON CORPORATION.
Chapter 1
PRODUCT DESCRIPTIONS
Provides a general overview and basic specifications, specifications of controls, inter-
faces, consumable supplies, and after service parts.
Chapter 2
OPERATING PRINCIPLES
Describes the configuration of each mechanism, theory of operations of the basic mech-
anisms and controls in this product.
Chapter 3
TROUBLE SHOOTING
Describes the step-by-step procedures of the trouble shooting.
Chapter 4
DISASSENBLY & ASSEMBLY
Describes the step-by-step procedures for disassembling and assembling the compo-
nents.
Chapter 5
APPENDIX
Provides maintenance information (After service menu etc.) required for servicing the
product.
To Next Page
Loading...
Need help?
General
