0-6
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
Other Caution
Since the lamp of this product contains mercury, be sure to dispose the used lamp pursuant
to the government’s law and regulations.
Never use or replace with any service parts that is not specified by EPSON.
Be sure to perform the repair/maintenance work on the even and stable work bench to
prevent the product from dropping down or mal-operation due to the improper setting
of the product.
Be sure to wear the gloves during the repair/maintenance work to avoid injuries by the
parts with sharp edges such as metal plate or the like.
To protect sensitive circuitry, follow the instructions below.
• When disassembling or reassembling, be sure to wear static discharge equipment
such as an anti-static wrist strap and a mat.
• When replacing the circuit component such as a board or the optical engine, be
sure to contact the anti-static case containing the new one to the metal part of this
product before taking it out.
When performing the repair/maintenance work, be sure to use the specified tools and
follow the instructions that are specified in the documents (service manual etc.) con-
cerning to this product.
When carrying out the test operation, do not block the intake and exhaust ducts.
(Such an action raises the internal temperature and may cause a fire or a damages to
the internal parts of this product.)
Be careful not to drop a metal part such as a screw, a washer, or a clip into the inside
of the product. If such cases should occur accidentally, never turn on the power supply
until all the dropped parts are found and removed.
After reassembling the product, check the followings before turning the power on.
• All the parts and screws are installed and secured to the proper positions.
• No cables are caught in the metal frames.
To Next Page
Loading...
Need help?
General
