204
Solving Problems
Check these sections for solutions to problems you may have using your product.
Note: Your product may differ from the images in this guide, but the instructions are the same unless
otherwise noted.
Scanner Light Status
Solving Scanning Problems
Scanner Light Status
The lights on the scanner indicate the scanner status and let you know when a problem occurs. Check
the status of the lights and look for a solution in the table here.
Light status Condition/solution
The error light is flashing
A paper jam or a double feed has occurred. Open the scanner cover
and remove any jammed originals. Close the scanner cover to clear the
error and load the originals again.
This product uses two different positions for scanning, depending on the
original being scanned. Check the link at the end of this section to see
which position is appropriate for your original.
The error light is on
The scanner cover is open. Make sure the scanner cover is closed and
there is no jammed paper inside.
The scanner position light
is flashing and the error light
is on
The scanner position was changed during scanning. Open the scanner
cover, remove the original, and return the scanner to its original
position.
The scanner position light
is flashing quickly
The scanner position has not been set. Set the scanner in the vertical
path position or straight path position.
To Next Page
Loading...
