Front Sheet Guide
Note: When the optional front sheet guide is installed in the
printer, the tractor unit cannot be mounted in the front position
and you cannot use the front push tractor.
Loading single sheets from the front
1.
Place the paper-release lever in the single-sheet position.
2.
Turn on the printer. The
READY
light on the control panel comes
on.
3.
Move the left edge guide to the arrow mark on the front sheet
guide. If you wish, you can slide the edge guide to the left in
1/10-inch increments to increase the left margin on your
printout. Next, adjust the right edge guide to match the width of
your paper.
4-26
Using the Printer Options
To Next Page
Loading...
