Using Continuous Paper
Adjusting the top-of-form position
The printer feeds the paper to the top-of-form position when it loads
the paper or performs a form feed. This position determines where
the printing begins on the page.
You may need to adjust the top-of-form position when printing on
ready-made forms. To do this, see Adjusting the loading position on
page 3-15.
Note:
When you are using the pull tractor, do not use the
TEAR
OFF
or
ALT+ EJECT
buttons.
Removing paper from the pull tractor
1.
Tear off the paper entering the printer at the perforation.
2.
Hold down the
PAPER FEED
button to feed the continuous paper
forward and eject it.
Paper Handling
2-19
To Next Page
Loading...
