Micro-Feed
The micro-feed feature allows you to move the paper forward or
backward in 2/216-inch increments. You use this feature to adjust
the loading and tear-off positions, as well as the print position
during a print job.
When you make adjustments to the loading or tear-off positions for
continuous paper, the printer remembers the new setting even if you
turn off the printer. The printer automatically advances the paper to
the new position when the power is turned on again.
When you adjust the loading position for single-sheet paper, the
printer remembers the new position only until you turn off the
power. The loading position returns to the factory setting when the
power is turned on again.
Adjusting the print position
Follow the steps below to adjust the print position during a print
job:
1.
Press the
PAUSE
button to stop printing.
2.
While holding down the
ALT
button, press the
PAUSE
button to
enter the micro-feed mode. The
FONT
and
CONDENSED
lights
blink alternately.
Using the Printer
3-15
To Next Page
Loading...
