Changing Group 4 default settings
Group 4 default settings differ from 1 to 3. You determine the setting
by the number of beeps you hear instead of checking the panel
lights. Also, the printer does not print a list of Group 4 default
settings. To change Group 4 default settings follow the steps below.
1.
Make sure the printer is turned off.
2. Hold down the
PAUSE
and
PAPER FEED
buttons while you turn
on the printer. You then enter the Group 4 default-setting mode.
3.
Press the
FONT, PAUSE,
or
PAPER FEED
button if you want to
change the current setting. The printer beeps once or twice to
indicate your setting.
Button
Feature
PAUSE
Input buffer
PAPER FEED
Draft print speed
Settings
Valid
Invalid
High
Normal
Beeps
Twice
Once
Twice
Once
FONT
Auto carriage return
Valid
Invalid
Twice
Once
For example if you press the
PAUSE
button, the input buffer
becomes invalid and the printer beeps once.
Note:
l
If you don’t press any button within a few seconds after
entering this mode, the printer beeps five times and
automatically exits the Group 4 default-setting mode, leaving
~
0
the settings unchanged.
Once you change a feature’s setting, you cannot change it
again without first exiting and re-entering the Group 4
default- setting mode.
4.
After you make your changes, wait until the
READY
light comes
on. This shows that the printer has automatically exited the
setting mode and you can begin printing.
3-14 Using the Printer
To Next Page
Loading...
