1.
Print on continuous paper loaded on the front or rear push
tractor (as described in Chapter 2). When you finish printing, the
printer advances the final p&ted page’s perforation to the tear-
off position.
2.
Tear off all printed pages.
Note: If the perforation does not meet the tear-off edge, you can
adjust the tear-off position using the micro-feed feature as
described on page 3-15.
I
3.
When you resume printing, the printer automatically feeds the
paper back to the loading position and begins printing.
You can leave tear-off mode on even when you are using single
sheets because tear-off mode is disabled when you move the paper-
release lever to the single-sheet position.
When you are using the pull-tractor, you need to set the tear-off
mode to invalid in the default setting mode.
Using the TEAR OFF button
You
can use the
TEAR OFF
button to advance continuous paper to the
tear-off position even if the tear-off mode is set to invalid in the
default-setting mode. Just follow the steps below:
1.
Make sure printing has finished.
2.
Press the
TEAR OFF
button. The printer advances the paper’s
perforation to the tear-off edge and the
READY
light blinks.
3.
Tear off all printed pages.
Note: If the perforation does not meet the tear-off edge, you can
adjust the tear-off position using the micro-feed feature as
described in the next section.
Using the Printer
3-19
To Next Page
Loading...
