Default-Setttng Mode
IBM mode character table
FONT COND.
light light
OFF OFF
OFF OFF
OFF
ON
OFF
ON
READY
light
ON
BLINK
OFF
ON
IBM mode Character tables
PC437 (table 1)
PC437 (table 2)
PC865 (table 1)
PC865 (table 2)
4.
Press the Font button to select the character table. The
FONT,
CONDENSED
and
READY
lights turn on, off, or blink to show your
selection.
For example, if you select PC437 (USA, standard Europe), the
FONT
light is on, the
CONDENSED
light is off, and the
READY
light
is off.
5.
After you have made your selection, exit the Group 2 default-
setting mode by turning off the printer.
Note: If you want to check the new default settings, enter the
default-setting mode again and print the quick reference. After
that, turn off the printer to exit the default-setting mode.
Changing Group 3 default settings
1.
Make sure the printer is turned off.
2.
To enter the Group 3 default-setting mode, turn on the printer
while you hold down the
FONT
and
PAPER FEED
buttons. The
printer beeps once.
3.
Load single-sheet or continuous paper. The printer then
automatically loads the paper and prints a quick reference.
3-12 Using the Printer
To Next Page
Loading...
Need help?
General