Testing the Printer
The printer prints the default settings, followed by font samples
for each of the printer’s available fonts.
5.
The self test continues until the paper runs out or until you press
the
PAUSE
button. When the printer beeps, you can load another
sheet of paper to continue printing font samples. When you wish
to stop the test temporarily, press the
PAUSE
button. To resume
the test, press the
PAUSE
button again.
6. While holding down the
ALT
button, press the
EJECT
button to
eject the paper. Then turn off the printer to end the self test.
Here is part of a typical self test.
--- CIJRRECIT
SETTIl’ICi
--I-.-
I”ri.11 ter
mode
EF’SOCI
l3c/I-
Character
spacinq
I.
0
c
u
i
SGrip-over--perforation
Ho
skip
Shape of
zercl
0
Tear off
V&id
hut<>
line
feed
Depentl!5
on
l/I-
Paoe
length
11
irlChC?!5
Note: If the self test does not print properly, see Chapter 6.
To Next Page
Loading...
