Control Panel
ALT
The
FONT
button also functions as the
ALT
button. Hold it down
while pressing another button for the following functions:
Eject (Hold down
ALT
and press
PAPER FEED.)
If the paper-release lever is in the single-sheet position, paper is
ejected. If the paper-release lever is in the front- or rear-tractor
position, paper moves back to the paper-park position.
Entering the Micro-feed mode (Hold down
ALT
and press
PAUSE/
TEAR OFF
when paper is already loaded in the printer.)
Micro feed allows you to move the paper forward or backward
in 2/216-inch increments to adjust the loading and tear-off
positions. See Micro Feed later in this chapter for details.
Bin select (Hold down
ALT
and press
PAUSE/TEAR OFF
when the
printer is out of paper.)
When you use the optional double-bin cut-sheet feeder, you can
select the bin before loading paper. For more information, see
Cut-Sheet Feeders in Chapter 4.
Other control-panel features
Default-setting mode: See the next section for details.
Self test:
Hold down the
PAPER FEED
button while you turn
on the printer to perform the self test. The self test
lets you see that your printer is operating properly
and provides a printout of the current default
settings. See Testing the Printer in Chapter 1 for
details.
Data dump:
Hold down the
PAUSE
button while you turn on
the printer to enter the data dump mode. This
mode allows advanced users to find the cause of
communication problems between the printer and
the computer. For instructions, see Data Dump
Mode later in this chapter.
3-4
Using the Printer
To Next Page
Loading...
