Printing
l
The font selected by the control panel does not print.
Your software may be overriding your panel setting. Check the
font setting in your application program.
l
The wrong characters are printed.
The wrong character table or the wrong international character
set may be selected. Check the default settings. See page 3-5.
The print position is not what you expect.
l
Printing starts too high or too low on the page.
Adjust the top margin set by your application software. Use
micro feed to adjust the print position.
l
All text is printed on the same line.
Set the automatic line feed on in the default-setting mode so
that the printer automatically adds a line-feed code to each
carriage return. Check the default settings. See page 3-5.
l
The text is printed with blank lines between the lines of text.
Two line-feed signals are being sent. Set automatic line feed off
in the default-setting mode.
l
The page length does not match the length of your continuous paper.
Change the page-length setting in the default-setting mode. See
page 3-5.
Check the page length set by your application software and
adjust it if necessary.
6-6 Troubleshooting
To Next Page
Loading...
