Cut-Sheet Feeders
0
t
CAUTION: Do not use envelopes, multi-part forms,
0
I
carbon
paper,
or labels in the single-bin cut-sheet feeder.
J
5.
6.
7.
8.
Insert up to 50 sheets of paper along the left paper guide.
Adjust the position of the right paper guide so that it matches
your paper’s width. Make sure the position of the guide allows
the paper to move up and down freely.
Push the paper-set levers back to clamp the paper against the
guide rollers.
Attach the stacker-support wires to the edge guides of the paper
guide. Then place the notches on the paper guide straight down
over the mounting posts on the printer to reinstall it. Slide the
edge guides to the middle of your paper.
You can still insert single sheets using the paper guide or the
optional front sheet guide. The cut-sheet feeder automatically loads
paper when you send print data to the printer (as long as the READY
light is lit). You can also load paper from the cut-sheet feeder by
pressing the
PAPER FEED
button.
Using the Printer Options
4-5
To Next Page
Loading...
