Cut-Sheet Feeders
Switching to the cut-sheet feeder
1.
If any printed sheets remain in the printer, press the
TEAR OFF
button to advance the continuous paper to the tear-off position.
2.
Tear off the printed pages.
3.
While holding down the
ALT
button, press the
EJECT
button. The
printer feeds the continuous paper backward to the paper-park
position. The paper is still attached to the push tractor but is no
longer in the paper path.
0
1
CAUTION: Never feed labels backward. Labels can easily
l
come off their backing and jam the printer. See the
instructions below.
4.
Place the paper-release lever in the single-sheet position.
If you are printing labels, follow these instructions to remove the
label supply and switch to the cut-sheet feeder:
1.
Tear off the fresh supply at a perforation below the push-tractor.
2.
Hold down the
PAPER FEED
button to eject the remaining labels.
The labels are no longer attached to the push-tractor.
3.
Place the paper-release lever in the single-sheet position.
4-12
Using the Printer Options
To Next Page
Loading...
