94
Network Scanning
5. Follow the instructions on the screen to
continue the installation. When you see the
window to the right, enter the IP address of
the scanner server in the Network Scanner
Address box.
6. Click
Test
to test the connection. If your
computer is communicating with the scanner
server and the scanner is on, you see a message
that the scanner is available. Then click
OK
to
save your settings.
If you need to connect to a different GT-30000 scanner or change the
timeout setting, you can open the EPSON TWAIN HS Network window
any time by double-clicking the EPSON TWAIN HS Network icon in the
Control Panel. You can enter up to five IP addresses or host names in the
Network Scanner Address box. You can remove a network scanner
address by selecting it in the list and clicking the Delete button.
7. Follow the instructions on the screen. When
you see the Screen Calibration window, move
the slider right or left until the stripes match as
closely as possible. (The stripes will not match
perfectly. The recommended setting is 1.8.)
Then click
OK
.
The EPSON Screen Calibration Utility
calibrates the preview image you see in your
EPSON TWAIN HS driver to match your
monitor settings
.
To Next Page
Loading...
