Solving Problems
Checking the Printer Status
Checking Error Codes on the LCD Screen
A code is displayed on the LCD screen if there is an error or information that requires your attention. If a code is
displayed, follow the solutions below to solve the problem.
Code Situation Solutions
E-01 A printer error has occurred. Open the inner cover and remove any paper or protective material
inside the printer. Turn the power
o
and on again.
E-02 A scanner error has occurred. Turn the power o and on again.
E-11 An ink pad needs to be replaced. Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part.
However, non-printing features such as scanning are available.
E-12 A borderless printing ink pad needs
to be replaced.
Contact Epson or an authorised Epson service provider to replace the
borderless printing ink pad*. It is not a user-serviceable part.
Borderless printing is not available, but printing with a border is
available.
W-01 A paper jam has occurred. Remove the paper from the printer and press the button displayed on
the bottom of the LCD screen to clear the error. In some cases, you
need to turn the power
o
and on again.
W-11 An ink pad is nearing the end of its
service life.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part. The message will be
displayed until the ink pad is replaced.
Press the
x
button to resume printing.
W-14 A borderless printing ink pad is
nearing the end of its service life.
Contact Epson or an authorised Epson service provider to replace the
borderless printing ink pad*. It is not a user-serviceable part. The
message will be displayed until the ink pad is replaced.
Press the
x
button to resume printing.
I-22
Set Wi-Fi from the Push Button
(WPS).
Push the access point button. If there is no button on the access
point, open the access point setting window, and then click the
button displayed in the software.
I-23
Set Wi-Fi from the PIN Code (WPS).
Enter the PIN code displayed on the LCD screen into the access point
or computer within two minutes.
I-31
Set Wi-Fi from the Wi-Fi Auto
Connect.
Install the software on your computer, and then press the OK button
when Wi-Fi setup starts.
I-41
Paper Setup Auto Display is
disabled. Some functions cannot be
used.
If Paper Setup Auto Display is disabled, you cannot use AirPrint. To
use AirPrint, enable Paper Setup Auto Display.
User's Guide
Solving Problems
167
To Next Page
Loading...
Need help?
General
