Paper Handling 15
2
2
2
2
2
2
2
2
2
2
2
2
Using the tractor in the front push position
This section provides instructions on “Installing the tractor in the
front push position” on page 15, “Loading paper with the front
push tractor” on page 17, and “Removing the tractor from the
front push position” on page 22.
Installing the tractor in the front push position
Before installing the tractor in the front push position, remove it
from its current position. If the tractor is in the rear push position,
remove the paper guide and then press the tractor’s lock tabs
while lifting it out. If the tractor is in the pull position, remove it
following the instructions in “Removing the tractor from the pull
position” on page 40.
Note:
The tractor is installed in the rear push position when the printer is
shipped.
1. Make sure the printer is turned off. If necessary, install the
paper guide on your printer as described in “Assembling the
Printer” in the Setup Sheet.
To Next Page
Loading...
