Epson RC90 User Manual

1. Introduction
6 RC700 / RC90 Option Fieldbus I/O Rev.14
1.3 PROFIBUS DP
1.3.1 Overview of PROFIBUS DP
PROFIBUS DP is a fieldbus network that provides easy interconnection between control
devices (PLC, PC, sensor, actuator, etc.).
PROFIBUS DP was co-developed by Siemens, Bosch, and ABB as an open
communication standard to connect various field devices (sensor, actuator, Robot
Controller, etc.). Because of the open communication standard, PROFIBUS DP can easily
construct multi-vendor system with various devices developed around the world.
Master Device
Motor Driver
from Company B
Intelligent I/O
from Company C
Intelligent I/O
from Company D
Photo Sensor
from Company E
Analog Device
from Company G
HMI Device from
Company F
Motor Driver
from Company A
PROFIBUS-DP Network
1.3.2 Features of PROFIBUS DP
Reduced Wiring
Compared with a parallel wiring, PROFIBUS DP employing dedicated 2-wire cable
substantially reduces the number of necessary wires, wiring time and cost.
Detachable communication connector provides you a simple wiring between devices
(stations) and an easy network separation or reconstruction.
Fast Communication
PROFIBUS DP communication speed can be set up to 12Mbps. This is faster than
DeviceNet, another communication standard supported by the fieldbus I/O.
Open Standard (Multi-vendor)
Due to an open communication standard, various devices from many manufacturers are
available. Standardized communication connectors allow you to reconstruct your network
easily.
Maintenance parts stored on site (factory, etc.) can be reduced because different
manufacturers’ devices can be used in case of a breakdown. Similar products are available
around the world due to a global standard PROFIBUS DP.

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English