Epson RC90 - 2.3 EtherNet;IP

2. Installation
RC700 / RC90 Option Fieldbus I/O Rev.14 127
2.3 EtherNet/IP
WARNING

Make sure that the power is turned OFF before
installing/removing any boards or
connecting/disconnecting any cables. Installing/removing any boards or
connecting/disconnecting any cables with the power ON is extremely hazardous
and may result in electric shock and/or malfunction of equipment.
2.3.1 How to Setup a EtherNet/IP Network
The following is a basic procedure for setting up an EtherNet/IP network:
1. Choose node layout and pathway in your network.
For details, refer to the following section 2.3.2 EtherNet/IP Network Construction.
2. Lay cables.
For details, refer to the following section 2.3.2 EtherNet/IP Network Construction.
3. Configure nodes.
For details, refer to respective manuals of your desired nodes.
4. Turn ON the nodes.
5. Install the EtherNet/IP board manufactured by Hilscher in the Controller.
When installing the EtherNet/IP master board manufactured by molex,
refer to 2.3.3 Installing EtherNet/IP Master Board manufactured by molex.
When installing the EtherNet/IP slave board,
refer to 2.3.5 Installing EtherNet/IP Slave Board.
6. Operate the EtherNet/IP network.