2. Installation
RC700 / RC90 Option Fieldbus I/O Rev.14 27
Installing Software
Before adding DeviceNet master boards manufactured by molex to the PC with the
EPSON RC+ 7.0 installed, you must install the applicomIO Console application and
drivers according to the type of the board you are using.
1. Insert the applicomIO Console CD-ROM to the PC with the EPSON RC+ 7.0
installed.
2. The dialog box shown below appears. Select “Run setup.exe”.
3. The [Summary] dialog box appears. Select “Product Installation”.
4. The [Installation] dialog box appears. Select “applicomIO”.