Epson RC90 - Control System Configuration

RC700 / RC90 Option Fieldbus I/O Rev.14 v
Control System Configuration
This option is used with the following combinations of Controllers and software.
TYPE A:
Controller
Software
RC700 EPSON RC+ 7.0
RC90-B
EPSON RC+ 7.0
TYPE B: Robot Controller RC90 with the following label attached.
Label
Controller Software
RC90 EPSON RC+ 7.0
RC90 controller firmware
Ver.7.0.2.0
EPSON RC+ 7.0
Before Ver.7.0.1
!!!
Ver.7.0.2 or later
OK
OK: Compatible All functions of the EPSON RC+ 7.0 and the Controller are
available.
!!!: Compatible Connection is OK. We recommend using EPSON RC+7.0 Ver.
7.0.2 or later.
TYPE C:
Manipulator
Software
T series
EPSON RC+ 7.0
VT series
EPSON RC+ 7.0
Ethernet/IP, PROFINET, and EtherCAT of this option are not available for Robot
Controller RC90 (EPSON RC+ 5.0) without the label.
Refer to the Robot Controller RC90 Setup & Operation 13.3 Fieldbus I/O Board.
Manual PDF for TYPE B is available from EPSON RC+ 7.0 Ver. 7.0.2.
Electronic information file for TYPE B is available from EPSON RC+ 7.0 Ver. 7.0.2.
Fieldbus I/O supports the following OS.
Windows 7 Professional Service Pack 1
Windows 8.1 Pro
Windows 10 Pro

NOTE

NOTE

NOTE