D
Insert the new Maintenance Box 1.
c
Important:
Pay attention to the following since the
printer may not operate or print correctly
otherwise.
❏ Do not touch the green IC chip on the
side of Maintenance Box 1.
❏ Do not remove the film from the top of
Maintenance Box 1.
E
Close the cartridge cover.
Replacing Maintenance Box 2
The instructions for replacing Maintenance Box 2
(Maintenance Box for borderless printing) are as
follows.
The on-screen message reads Maintenance Box 2.
However, the product name for this consumable is
Borderless Maintenance Box.
c
Important:
Do not replace Maintenance Box 2 while printing.
Printing stops if the lock on Maintenance Box 2 is
released. If stopped in the middle of printing,
colors may vary and/or print quality may decline
once printing is resumed.
A
Remove the output tray.
Lift the edge of the output tray slightly to
remove it. Also remove the optional
SpectroProofer if installed.
B
Release the Maintenance Box 2 lock.
C
Pull Maintenance Box 2 out carefully so that it
does not tilt.
Caution:
If ink should get on your skin or in your eyes,
wash the affected area with water
immediately.
SC-P5000 Series User's Guide
Maintenance
133
To Next Page
Loading...
Need help?
General
