About Roll Paper Cutting
When performing borderless printing on roll paper, you can specify whether it is left and right borderless printing
or all edges borderless printing, and how to cut the paper in the printer driver's Roll Paper Option. The cutting
operation for each value is shown in the following chart.
Printer driver
settings
Normal Cut Single Cut Double Cut
Cutting Operation
Explanation
The default printer driver
setting is Normal Cut.
❏ The top area may become
slightly uneven depending
on the image since the
print operation stops
while cutting the top edge
of the roll paper.
❏ If the cut position is
misaligned slightly, small
parts of the image may be
shown on the top or
bottom of the adjacent
pages. If this occurs,
perform Adjust Cut
Position.
U “Maintenance” on
page 111
❏ When you print one page
only or print one page
multiple times, the
operation is the same as
that for Double Cut. When
continuously printing
multiple sheets, the
printer cuts 1 mm inside
on the top edge of the first
page and the bottom
edge of the subsequent
pages to avoid showing
margins.
❏ The top area may become
slightly uneven depending
on the image since the
print operation stops
while cutting the top edge
of the roll paper.
❏ The printed paper is
approximately 2 mm
shorter than the specified
size since the printer cuts
the paper inside the image
to avoid showing top and
bottom margins.
❏ After cutting the bottom
edge of the preceding
page, the printer feeds the
paper, and then cuts the
top edge of the following
page. Although this
produces 80 to 127 mm
cut-off pieces, the cut is
more accurate.
SC-P5000 Series User's Guide
Printing Varieties
75
To Next Page
Loading...
Need help?
General