-252
PAPER NOT STRAIGHT
Paper Out
Slippage occurred
and paper was fed
at an angle.
Reload paper. See
“Paper Feed or Paper
Jam Problems Occur
Frequently”.
RELOAD PAPER
Paper Out
Paper could not be
reversed into the
printing position.
Remove then reload the
paper so that the right
and bottom edges are
straight and in line with
the rows of punch holes
on the printer. See
“Paper Handling”.
Paper is set out of the
printable area.
Paper is set out of the
horizontal cutting
area.
Paper is not fully
ejected.
Cut the paper at the
paper insertion slot, then
reload paper.
PAPER NOT CUT error
was cleared.
Reload paper.
Optional Auto
Take-up Reel Unit is
not operating
correctly.
Check whether the unit is
operating correctly. See
“Troubleshooting on the
Optional Auto Take-up
Reel Unit”.
LOAD PAPER
Paper Out
Paper lever was
released during the
printing process or
another operation.
Set the paper lever to the
secured position. Start
printing again from the
beginning for best results.
REMOVE PAPER
Paper Out
Loaded paper is too
thick for head
cleaning.
Push the paper lever
down to remove the
paper. Head cleaning
automatically starts.
After cleaning, PAPER OUT
is displayed. Reload
paper.
To Next Page
Loading...
