-253
When the Operate light does not come on and mechanism
initialization does not start (even when the Power button is
pressed to turn on the printer), try the solutions listed for the
problem.
❏ Turn off the power and make sure the power cord is securely
plugged into the printer.
UNABLE TO PRINT If an error occurs, or
the ink compartment
cover is open, you try
to print a test pattern
(nozzle check, status
check, head
alignment, or paper
thickness pattern)
from the SelecType
settings.
After 3 seconds the
message disappears.
Press the Pause button to
exit the SelecType mode.
When an error or status
message appears again,
clear and perform
printing a test pattern
again.
INK OUT
Y/LM/M/LC/C/K
Ink cartridge(s) is
(are) empty.
Replace the ink
cartridge(s) as indicated
by the lights. See
“Replacing Ink
Cartridges”.
NO INK CARTRIDGE
Y/LM/M/LC/C/K
Ink cartridge(s) is
(are) not installed.
Install ink cartridge(s) as
indicated by the lights.
See “Replacing Ink
Cartridges”.
WRONG CARTRIDGE
Y/LM/M/LC/C/K
Wrong ink
cartridge(s) is (are)
installed.
Use the correct ink
cartridge(s).
OPTION I/F ERROR Wrong I/F card is
installed.
Install the correct I/F card
after turning off the
power.
SERVICE REQ
nnnnnnnn
All lights Flashing
A fatal error has
occurred.
Note the error number
“nnnnnnnn” and
contact your dealer. See
“Contacting Customer
Support”.
To Next Page
Loading...
