Epson STYLUS PRO 9400 - Page 249

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 249
6. Release the harness of the CUTTER SOLENOID ASSY. from the retaining clip
and the hooked tab of the IM Sensor Cover. See Figure 4-70.
7. Remove the three screws that secure the CUTTER HOLDER. See Figure 4-70.
 Three C.C.P. M3 x 8 screws
8. Pull out the harness of the CUTTER SOLENOID ASSY. through the notch of the
CUTTER HOLDER BRACKET, and remove the CUTTER HOLDER. See Figure
4-70.
9. Remove the Cutter. See Section 4.2.2.3 on page 218.
10. Release the hooked tab that secures the CR LOCK KICKER and remove it
together with the CUTTER CAP, SOLENOID SPRING, and the SOLENOID
SHAFT. See Figure 4-71.
Figure 4-70. Removing the CUTTER HOLDER
Figure 4-71. Removing the CR LOCK KICKER
 Set the tab and hooked tab of the CUTTER HOLDER into the
slots of the frame.
 Route the harness of the CUTTER SOLENOID ASSY. through
the notch of the hooked tab on the CUTTER HOLDER.
Figure 4-69. Reinstalling the CUTTER HOLDER
Tab and
Hooked
Tab
Notch
C.C.P. 3x8
CUTTER HOLDER
IM Sensor Cover
Hooked tab
Retaining Clip
CUTTER SOLENOID
ASSY. harness
Notch
CR LOCK KICKER
CUTTER CAP
SOLENOID
SHAFT
SOLENOID SPRING
Hooked tab