169
Related tasks
Cleaning the Encoder Strip (Carriage Scale) and Replacing the Air Filter
Printing Is Slow or Stops Intermittently
If printing is slow or stops in the middle of a print job, try these solutions:
• Make sure Print Direction is set to Bi-Direction (High Speed) in the Garment Creator software.
Disable any Uni-Directional settings.
• If you print from a USB memory device with a slow reading speed (4.63MB per sec or less), the print
head stops during printing and then continues. Use a USB memory device with a faster reading
speed.
Parent topic: Solving Printing Problems
Related topics
Printing from a USB Memory Device
Cannot Access the USB Memory Device
When you connect a USB memory device, an icon is not automatically displayed on the printer control
panel. Select USB File List from the Settings menu, or transmit data from a computer to the USB
memory device connected to the printer.
Make sure files on the USB memory device are saved in the root folder. Only prn files are displayed
when the device is connected to the printer.
Also check the Job History setting in the Garment Creator software. If all of the jobs are being stored,
there may not be room on your computer's hard drive for new file printing.
Parent topic: Solving Printing Problems
Related references
USB File List Menu Settings
Related topics
Printing from a USB Memory Device
Red Light Shines Inside the Printer
The red light always shines inside the printer. This is normal.
Parent topic: Solving Printing Problems