69
sensor being triggered in the middle of printing. If this happens, try placing the T-shirt over the platen as
shown.
If the sensor is still triggered, try the following:
1. Check that the platen height is set to position 3 for a standard T-shirt.
2. Remove the frame and smooth out the creases and slack.
3. Reduce the width of the White ink in the printer's Garment Creator software or the RIP software so
that the white under-base print does not extend outside the image.
Note: Be careful not to touch the T-shirt while printing as it can easily move out of position.
Parent topic: Loading a T-shirt on the Platen
Loading a Sleeve on the Sleeve Platen
Before printing, carefully load a sleeve onto the sleeve platen.
To Next Page
Loading...
