388
• Do not attempt to move the product while the casters are secured or the feet are lowered. Doing so
may cause the product to fall and cause damage or personal injury.
• When moving the product, make sure it is turned off, the power cables are unplugged from the outlets,
and all connecting cables have been removed. Avoid steps and uneven surfaces.
• Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or dust.
• Do not place or store the product outdoors.
• Do not place the product near excessive heat sources or in direct sunlight.
• Leave enough room around the product for sufficient ventilation. Do not block or cover openings in the
cabinet or insert objects through the slots.
• Keep the product away from potential sources of electromagnetic interference, such as loudspeakers
or the base units of cordless telephones.
• When connecting the product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a connector
in the wrong orientation may damage both devices connected by the cable.
• Do not put your hands inside the product and be careful not to trap your hands or fingers when
opening or closing the printer covers or maintenance cover.
• Do not sit on the product or place heavy objects on top of it.
• Do not let your hands or hair get caught in the roll paper unit while it is operating.
• Do not move the print head by hand; this may damage the product.
• Do not insert or drop metallic or flammable items into the openings on the product.
• Do not spill liquid on the product or use the product with wet hands.
• Do not insert or unplug the plug with wet hands.
• Do not use aerosol products that contain flammable gases inside or around the product. Doing so may
cause fire.
• Except as specifically explained in your documentation, do not attempt to service the product yourself.
• Unplug the product and refer servicing to qualified service personnel under the following conditions: if
the power cord or plug is damaged; if liquid has entered the product; if the product has been dropped
or the cabinet damaged; if the product does not operate normally or exhibits a distinct change in
performance. Adjust only those controls that are covered by the operating instructions.
• Leave the ink installed. Removing the ink cartridges or ink packs can dehydrate the print head and
may prevent the product from printing.
• Before storing the product, make sure the print head is positioned at the far right.
To Next Page
Loading...
