Epson TM-L90-i Technical Reference Guide

Chapter 1 Product Overview
37
1
Receipt Paper/Continuous Label Roll Paper
When using receipt paper/continuous label roll paper , be sure to use paper that meets the
following requirements.
Requirements for Black Mark
When using receipt paper/continuous label roll paper with black marks, be sure to use paper
that meets the following requirements.
• Black mark portions must be printed on the back of the paper (non-printing side).
•The reflecting rates of black mark portions [1] and non black mark portions [2] must meet the
combinations shown in t
he table below :
(Reflecting rates are measured by the Macbeth PCM-II (Filter D) meter, using the back of the
paper.)
Paper without intervals between labels, such as continuous label paper, paper with
perforated lines between labels, and paper with slits between labels, can also be used
under the same requirements.
Reflecting rate of black mark portion [1]
17%
less
16%
less
15%
less
14%
less
13%
less
Reflecting rate of the portion where
the black mark does not exist [2]
90%
more
85%
more
80%
more
75%
more
70%
more
Paper feed direction
[2]
[1]
Units: mmBack(non-printing side)
4 to 7.5
40 to 300
15 or
more
Preprintable area

Epson TM-L90-i Specifications

General

Type	POS printer
Character size	0.99 x 2.4 mm
Print technology	Thermal
Maximum resolution	180 x 180 DPI
Country of origin	China
Autocutter durability	2 million cuts
Mean time between failures (MTBF)	180000 h
Product color	Gray
Maximum roll diameter	90 mm
USB port	Yes
USB connector	Micro-USB Type-A, Micro-USB Type-B, USB Type-A
USB 2.0 ports quantity	4
Connectivity technology	Wired
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	5 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Wi-Fi	No
Ethernet LAN data rates	10, 100 Mbit/s
Package depth	300 mm
Package width	190 mm
Package height	240 mm
Package weight	3000 g
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	195 mm
Width	145 mm
Height	148 mm