108
The Initial Software Settings
To set the customized values and memory switches, see "Software Settings" on page 46.
Settings Initial Setting
Customized values
User NV memory capacity 1 KB
NV graphics memory capacity 384 KB
Print density Level 7
Print speed Level 10
Interface mode Automatic selection
Column emulation mode 48 column mode
Command execution during offline Enabled
Automatic paper
reduction
Extra upper space
reduction
Disabled
Extra lower space
reduction
Disabled
Line space reduction rate Not reduced
Line feed reduction rate Not reduced
Barcode height reduction
rate
Not reduced
Automatic power off time Disabled
Battery charge mode Mode 1
Operation mode when battery is low Mode 1
Memory switches
Transmission of status notice Transmits
Buzzer Settings
Buzzer sounds for low
battery warning
Enabled
Buzzer sounds for roll
paper end warning
Enabled
Buzzer sounds for error
occurrence warning
Enabled
Error signal output Enabled
Paper position
immediately after the
specific state
Function Select Disabled
Position Select Top Position
To Next Page
Loading...
