Chapter 3 Application Development Information
67
3
Settings
Select from the menu list on the left to check or configure the settings.
Information menu
You can check the settings as shown in the table below.
Enable the time server when using a certificate. Otherwise, the printer's Stored Date/Time
may not be set correctly and the wireless LAN may be unavailable. If this happens, enable
the time server, or initialize the Stored Date/Time from one of the following:
EpsonNet Config
EpsonNet Config (Web Version)
Wireless Communication Setting Initializing Mode
You can check the printer's Stored Date/Time from the dynamic status sheet.
Menu Settings
Basic Information
Administrator Name, Location, interface Card Model Name,
MAC Address, Hardware Version, Software Version, Model
Name,
Communication Standard, Network Mode, SSID, Channel,
Transmission Rate, Access Point MAC Address, Signal Condition,
Printer Status
TCP/IP
IPv4 Address
IP Address Settings (Acquiring the IP Address, IP Address, Subnet
Mask, Default Gateway)
Set Using Automatic Private IP Addressing (APIPA)
DNS/DDNS
DNS Server Addresses (IPv4) Settings (Acquire DNS Server
Address Automatically, DNS Server Addresses)
Domain Name Setting (Acquire Domain Name Automatically,
Fully Qualified Domain Name, Register the Network Interface’s
Address to DNS Server)
SNMP
Community (Read Only)
IP Trap (Trap1/2, Address, Community)
Bonjour
Bonjour (Disable/Enable)
Bonjour Name, Bonjour Printer Name, Location
Time Setting
Use Time Server
Time Server Address, Update Interval, Time Server Status
Timeout Print (LPR, RAW (Port9100))
ePOS-Print Version, ePOS-Print (Disable/Enable), Device ID
To Next Page
Loading...
