Chapter 2 Setup
53
2
Paper Layout Setting
You can make settings for paper type and size in Paper layout setting. Paper type is set to Receipt
paper (without black mark) as default.
In case of using the Receipt paper (with black mark), you must select the Receipt paper (with
black mark) for paper type.
When the paper layout setting and the actual paper you are using do not match,
the following
situations may occur.
•When Paper Type Setting is set to Receipt paper (without black mark) and receipt paper (with
black mark) is used, the printer detects paper out.
•When Paper Type Setting is set to Receipt paper (with black mark) and receipt paper (without
black mark) is used, a paper error occurs.
To make the Paper Layout Setting, there are following optio
ns available.
•Setting with the APD
Set the size of the paper that you are using correctly.
•Setting with the OPOS
See the “PTR_DI_SET_PAPERLAYOUT method” of your driver’s Application Development
Guide for details to make the settings.
•Setting with the ESC/POS command
See the “FS ( L <fn=33>” (Paper layout setting) of ESC/POS Command Reference for details to
make the setting
s.
•Setting with the ePOS-Print SDK
See “addLayout” method in ePOS-Print SDK User's Manual.
•Setting with the ePOS-Print API (available only with the Wi-Fi model)
See “addLayout” method in ePOS-Print API User's Manual.
For detailed information about the driver, see "Printer Drivers" on page 62.
For detailed information about ESC/POS command, see "ESC/POS Commands" on
page 56.
For detailed information about downloading the software and manuals, see "How to Get
Software and Manuals" on page 62.
To Next Page
Loading...
